If you scan the contents before the combination, you'll get a pop-up asking to add equipment, causing everything to be added to the project twice.
The intended flow for scanning combinations out of the warehouse is the following:
- Scan the combination itself.
- Scan the content of the combination.
- Seal the combination.
In warehouse terms, it’s like this: you scan the flight case to open it, then scan the contents as you place them inside the case.
However, we are currently looking into making this flow more intuitive by design, to prevent warehouse workers from making mistakes. This will come in an update in the near future.
Was this article helpful?
0 out of 0 found this helpful